En
g
lis
h
TS6800 T2HEVC
5
1.3.3 Programming the TV keys
1.3.3.1 Changing TV codes
The predefined TV codes are in the list annexed to these instructions (see appendix
A
). First identify the kind of TV you want
to control, and then follow the steps listed below:
1. Turn on the TV you want to control.
2. Press the
TV
button for about 2 seconds until the
LED
indicator on the remote control remains lit.
3. Enter the 3-digit code that corresponds to the brand of the TV you want to control using the numeric keys
0
-
9
.
4. If the code entered is valid, the
LED
will turn off. Otherwise, if it is wrong, it will flash a few times before going off. If this
happens, programming will terminate (start again from point 1).
5. Verify that the TV responds properly to the remote control keys, at least limited to basic functions. If not, repeat the
TV
programming key using another code among those on the list dedicated to the brand of your TV (resume from point 1).
If your brand is not in the list or none of the default codes allows you to control your TV, try to identify or define an
appropriate program by following one of the following methods.
1.3.3.2 Manual search of TV codes
1. Turn on the TV you want to control.
2. Point the remote towards the IR sensor on your television and keep it pointed in that direction throughout the procedure.
3. Press the TV button for about 2 seconds until the indicator
LED
on the remote control remains lit.
4. Press one of the following keys:
q
,
CH +
,
CH-
.
5. As soon as your TV responds appropriately to the command, turning off or changing channels (in accordance with the
key you pressed). Press
OK
to store the code. The
LED
will then turn off.
Verify that the TV responds properly to the other buttons on the remote control, at least limited to basic functions. If not,
continue the search for an appropriate code by repeating the procedure (resume from point 1).
1.3.3.3 Programming through learning
TV codes listed in appendix
A
already provide basic functions to control the TV. You can still extend the programs associated
with the default TV codes thanks to the learning function. To take advantage of learning programming, you must have the
original remote control of your TV. Use fresh batteries both for the remote to program the decoder and for the original one for
the TV.
1. Keep TV button pressed for about 4 seconds until the indicator
LED
blinks and then remains lit.
2. Point your original TV remote transmitter at the remote sensor on the IR sensor of the decoder remote control at a
distance of about 3 centimeters. Make sure the two IR sensors are aligned throughout the procedure.
3. Press once on the remote control button on the decoder remote you wish to program: the
LED
will begin to flash slowly.
4. Press once on the button on the original remote control of the TV set corresponding to the function to associate to that
button of the decoder remote control button you selected in the previous step. Once the command has been acquired,
the remote control of the decoder will be waiting for the next acquisition with the
LED
lit.
NOTE
The acquisition is not immediate; it may take up to 2 or 3 seconds.
5. Repeat the two previous steps, 3 and 4, for all keys to be programmed.
6. After programming of all keys you want, press
TV
to save the program and exit the learning mode.
NOTES AND WARNINGS
Before learning programming, we recommend using fresh batteries in both remotes.
TV
keys and
STB
are not programmable through learning.
1.3.4 Using the remote control
After having programmed the remote to control your TV, it will work like the original TV remote control, at least limited to
basic functions such as turning on and off, volume control and audio return channel.
To control the decoder or the TV, perform a single short press on the corresponding function keys
STB
(cable box) or
TV
(television) and point the remote at the IR sensor of the device concerned. Upon transmission of each command, the infrared
indicator
LED
on the remote control will light up.
