Teldat Teldat-Dm 776-I, Руководство пользователя

Страница: 7 / 18

Slow blinking Detection error (Strength: High or Low).
1.3 Configuration Commands
This chapter describes the power sourcing equipment (PSE) configuration commands and is divided into the follow-
ing sections:
• Viewing the PSE configuration prompt.
• PSE configuration commands.
1.4 Viewing the PSE configuration prompt
To access the configuration environment, do the following:
(1) At the GESTCON (*) prompt, enter PROCESS 4 (or P 4) or CONFIG.
(2) At the configuration prompt (Config>), enter NETWORK <interface_name> (interface_name is the name of
the Ethernet interface on which the PSE functionality can be used).
(3) To set specific POE parameters, use the available commands from the PSE configuration menu described in
this chapter. To access the menu corresponding to the specific parameters, enter the POWER-
SOURCING-EQUIPMENT command once inside the interface configuration.
*config
Config>net ethernet0/0
-- Ethernet Interface User Configuration –
ethernet0/0 config>?
description Enter interface description
input-buffers Number of rx buffers
ip Interface Internet Protocol config commands
ip-encapsulation IP transport mode in the ethernet frame
list Displays the current configuration
llc Displays the LLC configuration prompt
mac-address Adopt locally administered addresses
no
power-sourcing-equipment
Access to the Power Sourcing Equipment configuration
repeater Access to the repeater configuration
shutdown Change state to administratively down
update Update a level indicator
exit
ethernet0/0 config>power-sourcing-equipment
-- Power Sourcing Equipment configuration --
ethernet0/0 PSE config>
Certain commands are common to all device interfaces. These commands are described in the manual on common
configuration interfaces (Teldat-Dm772-I Common Configuration Interfaces).
1.5 Configuring PSE
This section describes the PSE configuration commands.
Command Function
? (HELP) Allows you to view the available commands, as well as the available options within
a command.
AVAILABLE-POWER Configures the available power value.
DEFAULT-
PORT-CONSUMPTION Configures the default power consumption value for each connected port.
ENABLE Enables power sourcing equipment.
LIST Lists the interface options configuration.
NO Sets the default of a particular option.
PORT Configures each port individually.
TRACE Enables tracing.
Teldat SA
1 Configuration
PoE Power over Ethernet 3