rif-timer
Set default RIF timer (2m)
speed
Set default speed (16Mbps)
token-ring
X/X
config>
The default values are as follows:
Command
Default Value
MAC-ADDRESS
00:00:00:00:00:00
PACKET-SIZE
2052 bytes.
RIF-TIMER
120 seconds.
SPEED
16 Mbps.
1.3.6 PACKET-SIZE
Changes the packet size of all Token Ring networks. Changing the
packet-size
value can greatly increase buffer
memory requirements.
The following table shows valid packet sizes for 4 Mbps and 16 Mbps networks.
Speed
Values (# of bytes).
4 Mbps
1470, 2052, 4399
16 Mbps
1470, 2052, 4399, 8130, 11407, 17749
Syntax:
token-ring
X/X
config>packet-size <packet size>
Example:
token-ring3/0 config>packet-size ?
1470
2052
4399
8130
11407
17749
token-ring3/0 config>packet-size 17749
token-ring3/0 config>
If you enter an incorrect value, an error message is displayed:
token-ring3/0 config>speed 4
token-ring3/0 config>packet-size 17749
CLI Error: Valid packet-size for 4 Mbps: 1470,2052,4399
CLI Error: Command error
token-ring3/0 config>
1.3.7 RIF-TIMER
Configures the
Routing Information Field
(RIF) timer, which measures (in seconds) the amount of time the router
keeps RIF information before it is refreshed. Default is 120 seconds.
Syntax:
token-ring
X/X
config>rif-timer <value>
Example:
token-ring3/0 config>rif-timer ?
<0s..1h>
RIF aging (Time value)
token-ring3/0 config>rif-timer 40
token-ring3/0 config>
1.3.8 SOURCE-ROUTING
Enables or disables end station
source routing
. Through this process, end stations can determine the route to other
network devices over bridges implementing source routing. This allows the IP protocol to reach nodes located on the
other side of the bridge in source routing mode. This option does not depend on whether the interface supports
source routing in packet transmission and reception for this type or not. Default is enabled.
1 Configuring Token Ring Interfaces
Teldat SA
4
LAN Interfaces
