Manufacturer Name
ASIAN POWER DEVICES INC. (APD)
Manufacturer Address
NO.5 LANE 83. LUNG-SOU ST, TAO-YUAN CITY, TAIWAN R.O.C.
Input Voltage
100-240 Vac
Input AC frequency
50-60 Hz
Output voltage
12.0 V
Output current
5.0 A
Output power
60.0 W
Average active efficiency
88.3%
Efficiency at low load (10%)
87.2%
No-load power consumption
0.12 W
C.3 Compliance
C.3.1 FCC Statement
C.3.1.1 Federal Communications Commission Interference Statement (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resid-
ential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s Authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including in-
terference that may cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is
not possible.
This device and its antennas(s) must not be co-located or operating in conjunction with any other antenna or trans-
mitter except in accordance with FCC multi-transmitter product procedures.
This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor environment only.
Important
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Teldat S.A.
Regulatory compliance and Safety information
Teldat Router Connect-104V
25
