Teldat BinTec Elmeg DECT200, Руководство пользователя

Страница: 18 / 125

elmeg DECT200 Multicell System / en / elmegDECT200M_en / starting.fm / 18.10.2013
V
e
rsion 1, 01.0
7
.2012
17 elmeg DECT200 Multicell System
bintec elmeg First steps
Setting up VoIP connections
Before you start registering the handsets, please make sure that there are sufficient accounts
available from your local VoIP PABX or from a VoIP provider, and that you have the login data to
hand. You can set up accounts from a maximum of ten different providers.
First configure the VoIP connections.
¤
Log in to the Web configurator (
£
page 57 ).
¤
Open the Settings
¢
VoIP providers page and create an entry for each provider
(
£
page 71 ).
Registering the handset
Handset registration must be initiated in parallel on the DECT Manager (a) and on the handset
(b). To do so, the handset must be located in at least one cell of the DECT network, i.e., close to
a base station which is registered on the DECT Manager.
a) On the DECT Manager
¤
Open the Web configurator and log in (
£
page 57 ).
¤
Open the Settings
¢
Handsets (
£
page 74 ) page and press the Add button. You can
decide whether you want to set up a handset with new data, or transfer the data from a
handset that has already been set up.
¤
Select the VoIP provider from the list and enter the login data for the account the handset is
to use to make calls.
¤
Start registering the handset for this account.
The DECT Manager is now ready for registering. A registration PIN is generated and displayed.
b) On the handset
¤
Start the registration procedure on the handset in accordance with the handset's user guide.
A message appears on the display stating that the handset is searching for a base that is ready
for registration.
If the handset has found a base, you will be asked to enter the registration PIN.
¤
Enter the four-digit registration PIN, produced on the DECT Manager, on the handset.
c) On the DECT Manager
¤
Confirm the message Registration successful. by clicking OK .
Once registration is complete, the handset returns to idle status. The handset name is shown in
the display. If not, repeat the procedure.
Immediately after registration, the handset is assigned the VoIP connection as the receive and
send connection (incoming calls are signalled on the handset and can be answered).
You can now make calls with the handset.
Please note
The handset name is either the Username or Display name for the VoIP account to which
the handset is assigned. You can set this in the Web configurator (
£
page 74 ).