Telair TIG 3000G, Руководство по эксплуатации и обслуживанию

Страница: 9 / 44

Vers. 001
TIG 3000 G
9
GB
3.3 Handling
Always observe safety and accident
prevention rules when lifting and handling.
Use lifting and handling equipment with ca-
pacity greater than the load to be lifted.
The generating sets, complete with their packag-
ing, can be handled using common lifting and
handling equipment. The packages have special
spacers to allow for transpallet forks insertion.
4 INSTALLATION
4.1 Preliminary information
Incorrect installation of the generating
set can cause irreparable damage to the
equipment and compromise the safety of the
user.
The generator must be installed in
such a way as to prevent water infiltration,
therefore, it must be protected especially
when installed under vehicles.
If generating sets are installed not in compliance
with the instructions in this manual, the Manufac-
turer will not be held responsible for any malfunc-
tioning or safety issues regarding the generating
set, pursuant to Machinery Directive 2006/42/CE.
Moreover, the manufacturer will not be liable for
any resulting injury or damage.
4.2 Instructions for generating set fixing
The generator is equipped with 2 support brack-
ets (fig.4, ref. 2) fixed on the sides that allow for
both wall mounting and floor mounting. 4 cylindri-
cal vibration damping mounts (fig. 4 ref. 1) and 2
omega shaped mounting brackets (fig.4, ref. 3)
are supplied, particularly useful for equipment fix-
ing in a hanging configuration.
4.2.1 Ventilation and protection
For cooling purposes, the generator lets cool air
in through the lower air intakes (fig. 5 ref. 1) and
expels warm air through the protected opening
(fig. 5 ref. 2). Exhaust gases are sent to the ex-
haust through the hole (fig. 5 ref. 3) on the bot-
tom.
Sufficient space for air circulation must be al-
lowed around the generating set hood; in particu-
lar, there should be a gap of at least 10 cm in
front of the ventilating holes.
In the event that the generator is installed in the
vicinity of a vehicle wheel, apply a suitable pro-
tector (splash guard) to prevent rain, mud and
sand raised by the wheel affecting the generator
or entering through the ventilation air inlet.