Telair ICEBERG SPLIT 7000, Руководство по установке и инструкция пользователя

Страница: 10 / 36

- 10 -
GB
SPLIT SPLIT
SPLIT SPLIT SPLIT
7000
Should the condenser unit be installed outside the
vehicle, do not place the air inlet hole against a wall,
which could limit the passage of air. If the unit is too
close to the ground (less than 40 cm), the hot air
exhaust from
Fig. 3 Ref. (2) - could be sucked back
in again by the air intake Fig. 3 Ref. (1) .
If you install the condenser unit inside the vehicle,
you must be careful to keep the flow of the inlet air
separate from that of the hot exhaust air, and also
prevent the hot exhaust air from getting inside the
vehicle.
To separate the two air flows, use a soft sponge
adhesive liner
Fig. 4 Ref. (3) , placing it against the
floor, in order to prevent the hot air coming out from
Fig. 4 Ref. (2) being sucked in through the air intake
Fig. 4 Ref. (1) .
After having prepared the area of installation of the
condenser unit, you should connect the gas pipes
and the extension cables, before finally fastening
the unit in place.
4
1 Outside cool air inlet
2 Hot air outlet
3 Soft adhesive sponge liner
1
2 3
5
1
2
3
The metal container has been set up so as to let
both gas pipes, the 2 extension cables and the 230
Volt feeding cable of the air conditioner out on three
directions: upward
Fig. 5 Ref. (1) , on the long side
Fig. 5 Ref. (2) and on the short side Fig. 5 Ref.
(3)
.
After selecting the best position, first take off the lid
Fig. 5 Ref. (A) in order to access the inside of the
condenser unit and then take off one of the other
two lids:
Fig. 5 Ref. (B) , if you have chosen the
outlet on the long side Fig. 5 Ref. (2) , or
Fig. 5 Ref. (C ) if you chosen the outlet on the short
side Fig. 5 Ref. (3)
.
B
A
C