TEL TAVRIDA ELECTRIC VCB15 LD, Руководство пользователя

Страница: 45 / 93

46
Before connection CM to ISM the compliance between ISM type (shown on ISM serial number plate - Figure 2)
and CM (applicability of CM for particular type of ISM are shown on CM designation label - Figure 5 and CM
packinig label - Figure 17) shall be confirmed.
Warning! If the CM label does not show the correct ISM type connection shall not be established. It can lead to
damage of the ISM. Contact your nearest Tavrida Electric partner for replacement.
Secondary cables between ISM and CM shall be installed according to the following instructions (Figure 74,
Figure 75, Figure 76). To achieve best possible protection against electromagnetic influences. The earthing point
3 shall be as close as possible to the CM. Unshielded parts of wires shall be not longer than 10 cm. Connec-
tions between the end of cable shields and ISM earthing points shall be not longer than 5 cm.
1
2
3
4
CM
HD ISM
Earthing point at CM and at HD ISM
Actuator cable
Lapp Ölflex classic 110 CY
2 x 1.5 mm² (or equivalent)1)
1)
The degree of coverage of the cable
shield shall be not less than 85 %.
1
4.2.5 Installation of secondary cables between ISM and CM
Figure 74
Secondary cables between HD ISM and CM
2
3
3
4