S500 Integrated Test System Administrative Guide
Specifications are subject to change without notice
PA-939 Rev. C / October 2014
4 of 33
Power distribution unit (PDU) connections and power distribution basics
The Model 42000-PDU consists of a 24 V DC output to supply EMO circuitry with power. This supply also provides 24 V DC
out through banana jacks. Additional outlets provided are two specially switched power outlets (factory configuration: Always
on), and three strips of four switched outlets (off only with EMO condition). Control is through a 25-pin D-sub connector.
Site Preparation & Installation
Unpacking the S500 system
The Keithley field service engineer (FSE) is responsible for unpacking the S500 system cabinet and the accessories (which
is in a separate box). However, it is recommended that the customer moves the crate and the accessories box to the area
where the system is going to be used. Here is a list of tools needed for unpacking:
•
Safety glasses
•
Gloves
•
Standard screwdriver
•
Socket wrench
•
Socket head: 19 mm (or 3/4 in.)
The following information will help you when you begin to unpack your system. The system is shipped in a wooden crate (see
next figure).
Figure 2: S500 system cabinet in shipping crate
