A-4
Appendix A — Jetta Power Supply Information
Replacement of Jeta +5 Volt Supply
1.
To install the replacement supply, slide it into place and install the front
mounting screws.
2.
Feed the small multi-wire cable from the new power supply through the hole
at the top left of the +5 Volt supply compartment (see
through the frame to the hole into the Multi-Output supply compartment. If
necessary, gain access from the front of the frame.
3.
In the Multi-Output supply compartment, connect the multiwire cable
connector to the mating connector at the top of the circuit board.
4.
In the +5 Volt supply compartment, ensure that the connector on that end of
the multiwire cable is securely attached to its mating connector.
Step 7
or 8
0851-02
Step 3
Step 4
Black
Step 2
Step 2
Blue Wire
Step 5
Brown
Wire
Step 6
Red
Black
V1
Two
Cables
Each
Todd Multi-Output Supply
Jeta +5 Volt Supply
Red
Figure A-1. Installation of Jeta +5 Volt Power Supply Assembly
Содержание Grass Valley 4000
