Tektronix DSA8200 Series, Руководство по обслуживанию

Страница: 63 / 196

Maintenance
DSA8200 Digital Serial Analyzer and Modules Service Manual
4- 5
Table 4- 2: Internal inspection check list (cont.)
Item Repair action Inspect for
Semiconductors Loosely inserted in sockets.
Distorted pins.
Firmly seat loose semiconduc-
tors. Remove devices that have
distorted pins. Carefully straight-
en pins (as required to fit the
socket), using long-nose pliers,
and reinsert firmly. Ensure that
straightening action does not
crack pins, causing them to
break off.
Wiring and cables Loose plugs or connectors.
Burned, broken, or frayed wiring.
Firmly seat connectors. Repair or
replace modules with defective
wires or cables.
Chassis Dents, deformations, and dam-
aged hardware.
Straighten, repair, or replace
defective hardware.
Cleaning Procedure — Interior.
To clean the instrument interior, do the following
steps:
1. Blow off dust with dry, low-pressure, deionized air (approximately 9 psi).
2. Remove any remaining dust with a lint-free cloth dampened in isopropyl
alcohol (75% solution) and rinse with warm deionized water. (A cotton-
tipped applicator is useful for cleaning in narrow spaces and on circuit
boards.)
STOP
. If, after doing steps 1 and 2, a module is clean upon inspection, skip the
remaining steps.
3. If steps 1 and 2 do not remove all the dust or dirt, the instrument may be
spray washed using a solution of 75% isopropyl alcohol by doing steps 4
through 8.
4. Gain access to the parts to be cleaned by removing easily accessible shields
and panels (see Removal and Installation Procedures ).
5.
Spray wash dirty parts with the isopropyl alcohol and wait 60 seconds for the
majority of the alcohol to evaporate.
6. Use hot (120
E
F to 140
E
F) deionized water to thoroughly rinse them.
7.
Dry all parts with low-pressure, deionized air.
8.
Dry all components and assemblies in an oven or drying compartment using
low-temperature (125
E
F to 150
E
F) circulating air.