Tektronix CMD 80, Руководство пользователя

Страница: 158 / 672

Analog: Manual Test (Signaling)
CMD 80 Digital Radiocommunication Tester User Manual
3–91
Press the HANDOFFS/TRANSITIONS softkey to display the HANDOFFS/
TRANSITIONS menu for the CALL ESTABLISHED mode. See Figure 3–64.
You use this menu to either handoff an established call to another network,
system, and/or standard or to make a local transition, such as from ANALOG
MS TESTS to ANALOG VOICE LOOPBACK.
NOTE . The menu displays the previous NETWORK HANDOFFS selections. The
selections are retained until you change them.
Figure 3–64: Handoffs/transitions menu for call established (MS tests)
To hand off an analog call, perform the following procedure:
1. In the NETWORK HANDOFFS side of the menu, select the network,
system, and standard to which you want to handoff the call. Table 3–6 on
page 3–92 lists the supported handoffs with all options installed.
2. To configure the the base station signal for the system to which you are
handing off, press the BS SIGNAL CONFIG softkey.
For information about configuring the operating parameters of an analog
base station, refer to ANALOG BS SIGNAL CNFG on page 3–160. For
information about configuring the operating parameters of a TDMA base
station, refer to TDMA BS SIGNAL CNFG on page 3–251.
3. Press the CALL softkey to select either MS TESTS or VOICE LOOPBACK.
This determines the state that the tester is in after you execute the handoff.
Handoffs/Transitions