Tektronix 1740A Series, Руководство пользователя

Страница: 43 / 368

Installation
2–8
1740A/1750A/1760 – Series Service Manual
The 1740A/1750A/1760–Series monitors operate at 50 and 60 Hz, over the range
of 90–250 Volts, without operator adjustment.
The 1740A/1750A/1760–Series of instruments are delivered from the factory
with a 60 Hz/117 V power cord, unless one of the power cord options was
ordered. Table 2–1 provides a description of the available power cord options
for these monitors.
Table 2–1: Power Cord Options
Power Cord Option Description
!($% '$"# "! ")$ "$
!& !" ")$ "$
'%&$ ")$ "$
"$& $ ")$ "$
)%% ")$ "$
For additional information see the Accessories foldout at the back of the manual.
No operational modifications are made to this monitor through internal jumper
settings.
Rear Panel Connectors
Signals into and out of the instrument are connected via the rear panel. Video
signals are input/output through the bnc connectors, except for the RGB staircase
signal which is input through the REMOTE connector. General information
about the rear panel connectors is provided in the following paragraphs. Figure
2–8 shows the rear panel configuration for a 1760–Series instrument. The only
difference between the 1760–Series rear panel and the other instrument rear
panels is the presence of the GBR outputs.
Mains Frequency and
Voltage Range
Power Cord Options
Operational Changes
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com