Tektronix 071-0833-02, Инструкция по эксплуатации

Страница: 15 / 69

Base Assembly
K4000 Transport Cart Instructions
7
Pencil Marks: first line should be 10 inches
from the bottom of the extrusion. For the first
leg assembly, turn extrusion so pencil marks
are on the inside. For second leg assembly,
pencil marks are also on the inside.
Bumpons are on the
inside of the extrusions.
Note:
Leg tube can be crushed if screw is over
tightened; maximum torque is 3-6 foot/pounds.
Clear Plastic Buttons (1 on each leg assembly)
Figure 4: Aligning the leg assemblies and the strut
4. Position the strut horizontally between the leg assemblies, as shown in
Figure 4, with the open side of the strut to the back. Line up the weld nuts
with the back grooves of each upright. Slide the strut down to the base of the
cart, adjusting the distance between the leg assemblies as needed. When
complete, make sure the strut is resting tight against the bumpons placed on
the legs.
5. Use the 3/16 inch Allen wrench to tighten the cap head screws. Tighten them
first snugly, then go back and tighten them firmly.