INSTALLATION
Installation Guide
18
Wake-up On LAN Connector (JP10)
The Wake-up On LAN function will allow the network to wake up a Soft Power
Down (Soft-Off) PC. However, if your system is in the Suspend mode, you can
wake-up the system only through an IRQ or DMA interrupt. To use the Wake-up
On LAN function, you must enable the “
Power On By Ring/LAN
” field in the
Power Management Setup
of the Award BIOS. Connect the cable that comes with
your LAN card to this connector on the system board. Refer to the add-in card’s
manual for details.
Note:
Your LAN card must support Magic Packet in order to use the Wake-up On
LAN function.
Wake-on-Ring Function (JP11)
The Wake-on-Ring function allows the modem to remotely power on the system.
Install an external modem (normally to COM2) and enable “
Power On by
Ring/LAN
” function in the
Power Management Setup
from the BIOS.
For the function to work for an
internal modem card
, you must also connect the
Wake-on-Ring cable on the modem card to the
Wake-on-Ring function connector
on the mainboard.
