8
5.2 SETTING THE OUTPUT CURRENT
1. Turn on the supply
2. Refer to Section 5.1 step 1 – 4 to give the voltage around 2-5V.
3. Turn
the
CURRENT COARSE TUNE KNOB [10]
and
CURRENT FINE TUNE KNOB [11]
anticlockwise reach the minimum current value.
4. Short the + and the –
MAIN TERMINAL [12, 14]
with a conductor.
5. Ensure the out indicator is on. Otherwise, press the
ACCIDENTAL PROTECTION KEY [2]
. Then
the
CV INDICATOR [5]
will off and the
CC INDICATOR [4]
will on.
6. Adjust
the
CURRENT KNOB [10, 11]
to give a desired output current.
7. Repress
the
ACCIDENTAL PROTECTION KEY [2]
to cut off the output.
8. Then
the
CC INDICATOR [4]
will off and the
CV INDICATOR [5]
will on.
9. Remove the conductor from the
MAIN TERMINAL
[12, 14]
.
10. Set to diesried voltage.
11. Connect the circuit to the
MAIN TERMINAL
[12, 14].
Caution:
z
Ensure the current is set to zero before short the
MAIN TERMINAL [12, 14].
Otherwise it will
damage the power supply.
z
Do not short the
MAIN TERMINAL [12, 14]
over 1 minute; it will damage the power supply.
