Teknor Industrial Computers VIPer 821, Техническое справочное руководство

Страница: 98 / 106

VIPer 821 - Technical Reference Manual
E-6
0D Initialize Video Interface Detect CPU clock.
Read CMOS location 14h to find out type of video in use.
Detect and Initialize Video Adapter.
0E Test Video Memory Test video memory, write sign-on message to screen.
Setup shadow RAM - Enable shadow according to Setup.
0F Test DMA Controller 0 BIOS checksum test.
Keyboard detect and initialization.
10 Test DMA Controller 1
11 Test DMA Page Registers Test DMA Page Registers.
12-13 Reserved
14 Test Timer Counter 2 Test 8254 Timer 0 Counter 2.
15 Test 8259-1 Mask Bits Verify 8259 Channel 1 masked interrupts by alternately turning off and
on the interrupt lines.
16 Test 8259-2 Mask Bits Verify 8259 Channel 2 masked interrupts by alternately turning off and
on the interrupt lines.
17 Test Stuck 8259’s Interrupts Bits Turn off interrupts then verify no interrupt mask register is on.
18 Test 8259 Interrupt Functionality Force an interrupt and verify the interrupt occurred.
19 Test Stuck NMI Bits (Parity/IO
Check) Verify NMI can be cleared.
1A Display CPU clock
1B-1E Reserved
1F Set EISA Mode If EISA non-volatile memory checksum is good, execute EISA
initialization. If not, execute ISA tests and clear EISA mode flag.
Test EISA Configuration Memory Integrity (checksum & communication
interface).
20 Enable Slot 0 Initialize slot 0 (System Board).
21-2F Enable Slots 1-15 Initialize slots 1 through 15.
30 Size Base and Extended
Memory Size base memory from 256KB to 640KB and extended memory above
1 MB.
31 Test Base and Extended
Memory Test base memory from 256KB to 640KB and extended memory above
1 MB using various patterns.
NOTE: This will be skipped in ISA mode and can be « skipped » with
ESC key in EISA mode.
32 Test EISA Extended Memory If EISA Mode flag is set then test EISA memory found in slots
initialization.
NOTE: This will be skipped in ISA mode and can be « skipped » with
ESC key in EISA mode.
33-3B Reserved
3C Setup Enabled
3D Initialize & Install Mouse Detect if mouse is present, initialize mouse, install interrupt vectors.
3E Setup Cache Controller Initialize Cache controller.
3F Reserved
BF Chipset Initialization Program chipset registers with Setup values.
40 Display virus protect disable or enable
41 Initialize Floppy Drive &
Controller Initialize floppy disk drive controller and any drives.
42 Initialize Hard Drive & Controller Initialize hard drive controller and any drives.
43 Detect & Initialize Serial/Parallel
Ports Initialize any serial and parallel ports (also game port).
44 Reserved
45 Detect & Initialize Math
Coprocessor Initialize math coprocessor