TEKNIX TKGF61BL, Инструкция по эксплуатации, Страница: 33 / 37

Care and maintenance
Looking after your appliance
Care and maintenance
Cleaning And Maintenance Of The Oven’s Front Door Glass
Remove the profile by pressing the plastic latches on both left and right sides as shown in
figure 23 and pulling the profile towards yourself as shown in figure 24. Then remove the
inner-glass as shown in figure 25. If required, middle glass can be removed in the same way.
After cleaning and maintenance are done, remount the glasses and the profile in reverse order.
Make sure the profile is properly seated in its place.
Figure 23 Figure 24 Figure 25
1
2
Rack Positions
It is important to place the wire grill into the oven properly.
Do not allow wire rack to touch rear wall of the oven. Rack
positions are shown in the next figure. You may place a deep
tray or a standard tray in the lower and upper wire racks.
Installing and removing wire racks
To remove wire racks, press the clips shown with arrows in the figure, first remove the
lower, and than the upper side from installation location. To install wire racks; reverse the
procedure for removing wire rack.
Changing The Oven Lamp
WARNING: To avoid electric shock, ensure that the appliance circuit is open before
changing the lamp. (having circuit open means power is off)
First disconnect the power of appliance and ensure that appliance is cold. Remove the glass
protection by turning as indicated in the figure. If you have difficulty in turning, then using
plastic gloves will help you in turning.
Then remove the lamp by turning, install the new lamp with same specifications.
Reinstall glass protection, plug the power cable of appliance into electrical socket and
complete replacement. Now you can use your oven.
Type G9 Lamp
Type E14 Lamp
Rack 4
Rack 3
Rack 2
Rack 1
220-240 V, AC
15-25 W
Figure 27
220-240 V, AC
15 W
Figure 28
33