TEKNIX TKGF61BL, Инструкция по эксплуатации, Страница: 15 / 37

Installing your gas cooker
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
section of these instructions,
Installing your gas cooker
Bringing it all together
Remove the injectors using a 7mm spanner and
replace the injector with the ones from the spare set.
Make sure you use corresponding diameters suitable to
the type of gas that is going to be used, according to
the information chart (which is also supplied in the gas
conversion kit).
Adjusting the minimum flame position
First of all, make sure that the appliance is unplugged
from the mains electrical supply and that the gas feed
is open. The minimum flame position is adjusted with a
flat screw located on the valve. As shown in the figures
below; for valves with a flame failure safety device, the
screw is located on the side of the valve spindle and for
valves without a flame failure safety device, the screw is
located inside the valve spindle. To make adjusting the
flame position easier, we recommend that you remove
the control panel (and the micro switch if your model
has one) during the alteration. The bypass screw must
be loosened for conversion from LPG to natural gas.
For conversion from natural gas to LPG, the bypass
screw must be tightened.
Bypass screw
Screw(inside
the hole)
Valve with flame failure device
Valve without flame failure
device
Determining the minimum flame
position
To determine the minimum position, ignite the burners
and leave them on in the minimum position. Remove
the knobs to gain access to the screws. With the help
of a small screwdriver, fasten or loosen the bypass
screw by around 90 degrees. When the flame has a
length of at least 4mm, the gas is well distributed. Make
sure that the flame does not die out when passing
from the maximum position to the minimum position.
Create an artificial wind with your hand towards the
flame to see if the flames are stable.
For the oven burner, operate the oven burner at the
minimum position for 5 minutes, then open and close
the oven door 2-3 times to check the flame stability of
the burner.
Bypass screw
Bypass screw
Thermostatic oven valve
Non-thermostatic
oven valve
Changing the gas inlet
For some countries, the gas inlet type can be different
for NG/LPG gases. In this case, remove the current
connection components and nuts (if any) and connect
the new gas supply accordingly. In all conditions,
all components used in gas connections should be
approved by local and/or international authorities. In all
gas connections, refer to the “Assembly of gas supply
and leakage check” clause explained above.
1.1. Electrical Connection
and Safety (if available )
WARNING: The electrical connection of this
appliance should be carried out by an authorised
service person or qualified electrician, according to the
instructions in this guide and in compliance with the
current local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
•
Before connecting the appliance to the power
supply, the voltage rating of the appliance (stamped
on the appliance identification plate) must be
checked for correspondence to the available mains
supply voltage, and the mains electric wiring should
be capable of handling the appliance’s power rating
(also indicated on the identification plate).
WARNING: This appliance must be installed
by an authorised service person or qualified
technician.
15