TEKNIX TKGF61BL, Инструкция по эксплуатации, Страница: 20 / 37

Functions
Functions
Simple everyday use
Use of gas burners
Ignition of the burners
The position symbol above each control knob indicates
the burner that the knob controls.
Ignition by igniter button:
Push in the knob
of the burner you wish to ignite and keep it pressed
while turning it anti-clockwise until the knob is in
Maximum position, now press the Igniter button which
will create sparks at the burner - Do not continuously
operate the igniter for more than 15 seconds. If the
burner does not ignite - Wait for 60 seconds before
trying again.
Manual ignition of the gas burners
If the igniter fails for any reason, follow the procedures
listed below.
For hob burners:
Push in the knob of the burner
you wish to ignite and keep it pressed while turning
it anti-clockwise until the knob is in the ‘maximum’
position. Continue pressing the knob and hold a
lit match, taper or other manual aid to the upper
circumference of the burner. Move the ignition source
away from the burner as soon as you see a stable flame.
For oven burner:
Push in and turn the oven
control knob anti-clockwise until the knob is in the
‘maximum’ position. Hold a lit match, taper or other
manual aid to the ignition hole that is located on the
front left corner of the burner. Move the ignition source
away as soon as you see a stable flame.
For grill burner:
Push in and turn the grill control
knob clockwise until the marker on the knob points at
the grill sign. Continue pressing the knob and hold a lit
match, taper or other manual aid to the holes on the
burner. Move the ignition source away from the burner
as soon as you see a stable flame.
Electrical ignition by spark button
Push in the knob of the burner you wish to ignite and
keep it pressed while turning it anti-clockwise until the
knob is in the ‘maximum’ position. While keeping the
knob pressed in, push the ignition button. Make sure
that you press the ignition button immediately as a
delay could cause a build up of gas which may result in
the flame spreading. Continue pressing the ignition
button until you see a stable flame on the burner.
Flame safety device
Hob burners
Hobs equipped with a flame failure device provide
security in case of an accidentally extinguished flame. If
such a case occurs, the device will block the burners
gas lines and will avoid any accumulation of unburned
gas. Wait 90 seconds before re-igniting an
extinguished gas burner.
Oven / Grill Burners
All oven burners are equipped with a gas safety device.
For this reason, during ignition, keep the oven knob
pressed until you see stable flames. If the flames are
cut out after you release the knob, repeat the ignition
procedure. If the oven burner does not ignite after you
keep the burner knob pressed for 30 seconds, open
the oven door and do not attempt re-ignition for at
least 90 seconds. If the oven flames go out
accidentally, repeat the same procedure.
1.2. Hob Controls
Hob burner
The knob has 3 positions: off (0), maximum (big flame
symbol) and minimum (small flame symbol). Ignite the
burner with the knob in the ‘maximum’ position; you
can then adjust the flame length between the
‘maximum’ and ‘minimum’ positions. Do not operate
the burners when the knob is between the ‘maximum’
and ‘off’ positions.
OFF position MAX position
MIN. position MODULATE
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
20