Teknatool nova PRO-TEK SUPERNOVA2, Руководство по эксплуатации

Страница: 15 / 41

15
Mounting the chuck onto a lathe
There are two configurations available for the PRO-TEK SUPERNOVA
2
Chuck:
• Insert model-Requires an insert adapter for chuck to be mounted on the lathe.
See full list in this manual of the NOVA (lathe spindle thread) insert adaptors
available.
• Direct Thread model: M33 ASR Eurolock
Both configurations will require identical procedures to be correctly mounted onto
the lathe however the insert version will require an insert adapter to be screwed into
chuck and then mounted onto the lathe.
The image below illustrates an insert version chuck mounting procedure on the lathe
however, identical procedures will apply for the direct threaded version:
1. If the chuck is an insert model,
ensure the insert is bottomed out
on the chuck body before mounting
on the lathe.
2. For both Insert & Direct Thread
model: Wind the chuck on the lathe
spindle until the chuck comes firmly
in contact with the bearing/ spindle
shoulder with no gaps in between.
Note: Make sure there is no grub
screw threaded onto the chuck
body or insert before threading
onto the lathe spindle.
Important: Left hand thread inserts
must be locked to chuck body or
chuck body could unwind from
insert.
3. Firmly tighten the chuck body/
insert using a chuck spanner
(Sold separately; SKU 23079)
4
1