118-0817-007 23
7.
Remove the old belt and place the new belt over the
Spindle End A
and on to
Pulley 2
.
NOTE:
Make sure the
new Belt
and
Pulley 2
are all on the spindle.
8.
Using a wooden mallet or plastic
hammer, start to tap the
Spindle
back into the headstock.
NOTE:
Before
Spindle end A
enters
Bearing 1
, double check that the
new Belt
and
Pulley 2
are on the
spindle.
9.
As the
Spindle end A
starts to enter
Bearing 1
, move
Pulley 2
back
along the
Spindle
. Gently tap the
spindle
until the groove for the
Circlip 1
can be reached for
installing
Circlip 1
.
10. Reinstall
Circlip 1
.
11. On the
Spindle
there is a small
horizontal grove for the
Pulley 2
Grub Screw
to sit in. Align the grub
screw hole in
Pulley 2
with this
horizontal grove and re-align the
steps of
Pulley 2
with
Pulley 1
.
Insert
Pulley 2 Grub Screw
in to
Pulley 2
and tighten snug.
12. Install the belt on the slowest speed
steps, tension correctly and tighten
the motor lock handle
13. Lower and lock the cover and test
the new belt at the slowest speed at
first, to make sure
Pulley 2
is not
slipping on the
Spindle
and that the
two pulleys are aligned correctly.
If it is slipping or the belt comes off
or starts to work its way off, repeat
step 13
.
Otherwise the lathe is now ready for
use.
