Installation MXSE
MOUNTING INSTRUCTION
Box Contents:
* Soap dispenser complete with cover, control unit
and soap container with dispenser spout.
* Key
Additional:
* 4 pcs Alkaline batteries 1,5V AA (Not included)
Use the back plate as template for placement of
drilling holes. Open the soap dispenser with supplied
key. Remove the soap container by lifting up the
spring-loaded cover that keeps the spout in place and
lift out the container and spout. Remove the control
unit for the pump as well. Fix four monting screws
suitable for the wall construction in the back panel
and attach it to the wall. Reinstall the controller. fill
the soap container and and place the soap container
in its place above the control unit. After cleaning the
tank and upon initial installation, the spout must be
filled with soap. Squeeze the spout until it is
completely filled with soap. Make sure that the spout
is in tension between the upper and lower part of the
control unit by placing by placing the plastic ring by
the spout on the lower side of the control unit when it
is inserted in place behind the cover. Close the
spring-loaded cover which keeps the spout in place.
Open the battery door on the side of the control unit
(right side) and insert four batteries 1,5V AA size. Test
that the soap dispenser works by pressing and
holding down the blue activity button on the bottom
of the disenser. This will initiate a blink 3-4 times from
the blue led light. Close the battery compartment
cover and lock the dispenser. Remove the protection
on the spout and place your hands under the soap
outlet and repeat sometimes until soap comes out.
Make sure everything is working correctly.
Selection of soap
The soap must be free of the following chemicals:
Chlorine and alcohol and iodine compounds. The
viscosity of the soap must be within the given range
and pH should be neutral.
Refill of soap: Soap can be refilled by taking out the
soap container, open the lid on the top, clean the
tank, refill soap and press the rubber spoat
sometimes so that the tube is filled with soap. Put
soap container in place of the control unit.
3
FDV Revision 20190829
www.intra-teka.com
