108
English
Support
Pin
then push the PUSH symbol fully in until it clicks
into place.
4. Remove the drip tray complete with grounds
container (A4).
5. Close the service door.
Cleaning the water tank
1. Clean the water tank (A12) regularly (about once
a month) with a damp cloth and a little mild
washing up liquid.
2. Clean to remove all washing up liquid residues,
then rinse the water tank thoroughly.
Cleaning the spouts
1. Clean the spouts (A13) periodically using a
sponge or cloth (fig. 25).
2. Check regularly that the holes in the coffee
spout are not blocked.
If necessary, remove coffee deposits with a
toothpick (fig. 23).
Cleaning the pre-ground coffee funnel
• Check regularly (about once a month ) that the
pre-ground coffee funnel (A21) is not blocked.
If necessary, remove coffee deposits with a knife
(fig. 17).
Danger!
Before performing any cleaning
operations, the machine must be turned off by
pressing the main switch (A23) and unplugged from
the mains power supply.
Never immerse the coffee maker in water.
Cleaning the inside of the coffee
maker
1. Check regularly (about once a week) that the
inside of the appliance is not dirty.
If necessary, remove coffee deposits with a knife
and a sponge.
2. Remove the residues with a vacuum cleaner
(fig. 26).
Cleaning the infuser
The infuser (A5) must be cleaned at least once a
month.
Important!
Do not use washing up liquid to
clean the infuser. It would remove the lubricant ap-
plied to the inside of the piston, causing the infuser
to seize up and become unusable.
5. Soak the infuser in water for about 5 minutes,
then rinse under the tap.
6. After cleaning, replace the infuser (A5) by sliding
it onto the internal support and pin at the bottom,
N.B.!
If the infuser is difficult to insert, you
must first adapt it to the right dimension by pressing
it forcefully from the bottom and top as shown in
the figure.
Important!
The infuser (A5) must not be re-
moved when the appliance is on. Do not attempt to
use force to remove the infuser as this could dam-
age the coffee maker.
1 Make sure the machine is correctly turned off
(see “Turning the appliance off”).
2. Open the service door (A2) (fig. 13).
3. Remove the drip tray (A14) and the grounds con-
tainer (fig. 14);
4. Press the two red release buttons inwards and
at the same time pull the infuser outwards (fig.
27).