IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
DATE
5-14-18
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]
REFERENCE NUMBER
INS-2569-02
BEACON POLE MOUNT™ (BPM)
WIRING DIAGRAM
Phase 1 - Install Pole
1. Install pole (By Others) with 3”x5” min. hand hole
according to lighting plan and manufacturer’s
installation instructions. Install conduit (By
Others) to be used with this product.
2. Pull wiring necessary for installation (By Others.)
Leave sufficient wire length in the pole for
future service.
Phase 2 - Fixture Installation (Hand Hole Option)
3. Open hand hole as per pole manufacturer’s
instructions, then pull primary branch circuit
wiring through conduit to splice location and
pull down fixture leads from installed pole top.
1. Thread fixture leads down pole to splice location
at hand hole.
2. Slide fixture over pole top. Secure with four (4)
1/4”-20 set screws using 3/16” Allen wrench.
Make sure the fixture is completely seated. Do not
overtighten.
Hand Hole Installation Instructions
4. Make watertight connections from primary
branch circuit to driver leads using waterproof
wire connectors (By Others). Connect green
ground wire to ground wiring from driver.
Connect incoming dimming controls to driver
primary side dimming controls. Connect
secondary side of driver to fixture leads.
See
wiring diagram.
LINE
Red
FIXTURE
COM
Driver
Black
GROUND
DIM +
DIM -
GROUND IN HOUSING
LINE
Red
FIXTURE
COM
Driver
Black
DIM +
DIM -
GROUND ON PLATE
LINE
Red
FIXTURE
COM
Driver
Black
DIM +
DIM -
5. Place connections and driver on bracket into
pole through hand hole. (For use with 3”x5” hand
hole).
7. Close hand hole cover with hardware and tools
as per pole manufacturer. (Pole and Hardware
By Others)
6. Driver bracket should hang off small horizontal
interior bar inside pole near hand hole. Use two
hooks on bracket to hang on interior bar.