IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
DATE
5-14-18
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]
REFERENCE NUMBER
INS-2569-01
BEACON POLE MOUNT™ (BPM)
Hinge Base Installation Instructions
Phase 1 - Install Pole
1. Install 3-1/2” O.D. pole (By Others) or pole with
3-1/2” O.D. tenon (By Others, Specify Separately)
according to lighting plan and manufacturer’s
installation instructions. Install conduit (By Others)
to be used with this product.
2. Pull primary branch circuit wiring necessary for
installation (By Others). Pull incoming dimming
controls necessary for installation. (By Others).
Leave sufficient wire length in the pole for
future service.
3. Make watertight connections from primary
branch circuit to driver leads using waterproof
wire connectors (By Others). Connect green
ground wire to ground wiring from driver.
Connect incoming dimming controls to driver
primary side dimming controls. Connect
secondary side of driver to wiring for fixture
leads.
See wiring diagram.
WIRING DIAGRAM
Phase 2 - Fixture Installation (Hinge Base Option)
LINE
Red
FIXTURE
COM
Driver
Black
GROUND
DIM +
DIM -
GROUND IN HOUSING
LINE
Red
FIXTURE
COM
Driver
Black
DIM +
DIM -
GROUND ON PLATE
LINE
Red
FIXTURE
COM
Driver
Black
DIM +
DIM -
2. Hinge pole open for access to conduit and
branch circuit wiring. Pull branch circuit wiring
and dimming controls to splice location.
1. Remove base cover (if required). Open hinge base
on pole by loosening three (3) 1/2”-13 stainless
steel bolts using adjustable crescent wrench.
4. Place driver, bracket and connections into pole.
Hinge pole back to upright position. Connect
secondary wiring to secondary side of driver.
Pull secondary wiring to top of pole. Length of
secondary wiring will vary with height of pole.
Leave length for future service.
5. Close hinge pole, then secure to base with
three (3) 1/2” I.D. flat washers, split lock
washers and three (3) 1/2”-13 stainless steel
bolts using an adjustable crescent wrench.
6. If pole comes with cover, place cover on base
of pole. Secure with four (4) 1/4”-20 hex screws
using 3/16” Allen wrench.