Teddington 100 E, Руководство по эксплуатации

Страница: 17 / 68

17 02.01.2013
ATTENTION
All specified anchor points on the air curtain system must be used on site! The mounting mate-
rials must be adapted to local conditions, checking structural stability where applicable. The
delivered mounting parts are standard parts which will not fit all building situations. It is there-
fore essential to check the suitability of mounting parts for the respective situation. Where nec-
essary they must be replaced. The installing company is solely responsible for the safe mount-
ing of the unit.
ATTENTION
All water and electrical installations must be performed exclusively by specialist companies
(such as HVAC companies, electricians). Teddington Luftschleieranlagen GmbH will otherwise
assume no liability.
9. Control unit of your air curtain system
You can find detailed information about the control unit of your air curtain system in seperate operating instruc-
tions. Please ensure that the serial number given on the cover is identical.
10. Maintenance of your air curtain system
As the ventilator motors and the other components of the air curtain system are low-maintenance, no system
maintenance other than regular cleaning is required. The cleaning intervals depend fundamentally on the air
curtain system’s application area. However, the system should undergo thorough cleaning at least twice a year.
The ventilator motor elements can be cleaned with a vacuum cleaner or a damp cloth (please observe the above
mentioned hazard warnings). Avoid strong alkali or acid-based cleaning agents! Do not clean the inside of the
casing with water or steam!
11. The most frequent malfunctions – and how to rectify these
Malfunction Possible cause What you can do
Air curtain cannot be
turned on
Building fuse is defective Reset fuse in the sub-distribution
Air curtain fuse is defec-
tive Change fuse; if the fuse burns out again, again it is
essential to consult an electrician or our customer
service
Short-term power surge Set selector switch to „zero“, then set again to se-
lected level
Motor overheated and/or
defective Motor defective, inform customer service or HVAC
company
Smells and smoke devel-
op on electrically heated
air curtains Appears often at the
beginning of the heating
period, caused by a dirty
heating element. Turn system off, use vacuum cleaner to clean the
heating element and air intake grid (if the fault is still
present after 30 - 45 minutes, please inform custom-
er service)
english