4
111
COOL, HEAT, and FAN ONLY Operation
1.
If the AUTO mode is not comfortable, you may manually override the settings by using COOL, DRY,
HEAT (HEAT PUMP units only), or FAN ONLY modes by pressing button
b
.
2. Push
the
▲
or
▼
button (
c
and
d
) to set the desired room temperature. When in COOLING mode, the
most comfortable settings are 21ºC or above. When in HEATING mode, the most comfortable settings
are 28ºC or below.
3. Push
the
Fan
button
e
to select the FAN mode of AUTO, HIGH, MED or LOW.
4. Push
the
On/off
button
a
. The operation lamp lights and the air conditioner starts to operate per your
settings. Push the
On/off
button
a
again to stop this unit operation.
DRY Operation
1. Push the
Mode
button
b
to select DRY.
2. Push the
▲
or
▼
button (
c
and
d
) to set the desired temperature from 21 C to 28 C.
3. Push the
On/off
button
a
. The operation lamp lights and the air conditioner starts to operate in the DRY
mode. Push the
On/off
button
a
again to stop this unit operation.
TIMER Operation
Push Timer on/off button (
i
and
j
) to set the on and off times of the unit. The effective operation time
set by the remote controller for the timer function is limited to a period of between 0.5 and less than 24
hours.
1.
To set the STARTING time.
1.1 Push the
Timer on
button
i
, then the remote controller display shows
ON TIMER
, the last set time for
the starting operation and the signal "
Hr
" will be shown on the digital display area. You are now ready
to reset the time to START the operation.
1.2 Push the
Timer on
button
i
again to set desired unit start time.
1.3 After setting the
Timer on
,there will be half a second delay before the remote controller transmits the
signal to the air conditioner. Then, after approximately another 2 seconds, the signal "h" disappears
and the set temperature will re-appear on the digital display.
2.
To set the STOPPING time.
2.1 Push the
Timer off
button
j
and the remote controller display will show
OFF TIMER
and the last set
time for the timer off operation in hours will be shown on the Timer display area. You are now ready
to reset the time of the STOP operation.
2.2 Push the
Timer off
button
j
again to set the time you want to stop the operation.
2.3 After setting the
Timer off
, there will be half a second delay before the remote controller transmits
the signal to the air conditioner. Then, after approximately another 2 seconds, the signal "h" disappe-
ars and the set temperature will re-appear on the digital display.
G
NOTE!
Due to the difference of the set temperature of the unit and the actual indoor temperature, the
Air Conditioner when in DRY mode will automatically operate many times without running the
COOL and FAN mode.
G
NOTE!
The FAN ONLY mode cannot be used to control the temperature. In this mode, only steps 1, 3 and
4 are applicable.
man_TSC126_uk.qxd 10-05-2007 15:41 Pagina 111
