Betriebsanleitung
–
Operating manual
P3922
www.tecsis.de
BD_BE 769
15
2 Configuration
To change device settings, press
Menu
(key 4) for 2 seconds.
This will call the configuration menu.
Pressing key
Menu
jumps between the parameters.
The parameters can be changed with
(key 2) or (key 5).
Quit
(key 6) finishes the configuration and returns to standard measuring operation.
2.1 Unit: Coice Of The Display Unit
Choose the desired display unit, the refering unit is displayed by means of
a functional arrow in the display. The selection is permanently stored in the
device, therefore after power on the unit will instantly reapear. The choice
depends on the used sensor. The unit [m] =mH
2
O is just supported by
devices with [m] printed below the display!
2.2 P.oFF: Auto Power Off Time
The device will be automatically switched off if no key is pressed/no
interface communication takes place for the time of the power off time.
The power off time can be set to values between 1 and 120 min. It can be
c
ompletely deactivated by setting the paramter to ‚P.oFF = oFF“.
2.3 Adr: Base Address of Interface
Up to 10 devices of the handheld-family can be connected to a serial
interface at once (depending on interface converter).
To get access to each device the base addresses of the devices have to
be different. For example choose 01 for the first, 11 for the second device
and so on.
MPa
Pa
bar
mbar
kPa
Tara
AL Logg
SL
PSI
mbar
MPa
Pa
bar
mbar
kPa
Tara
AL Logg
SL
PSI
MPa
Pa
bar
mbar
kPa
Tara
AL Logg
SL
PSI
mbar
