Tecsis E3907, Руководство по эксплуатации

Страница: 14 / 24

Operating manual
E3907
10 BE 984 i www.tecsis.de
Call menu "POINTDIS", after pressing ENTER the final value of the sensor can be entered, by
PLUS or MINUS the numeric character can be edited, by ENTER the next figure can be edited, if all
figures are edited, by PLUS and/or MINUS the comma will be shifted. For the completion of the
input press ENTER, thereafter the final value is being logged in the E3907
UNIT Input of the physical unit, e.g. Kg, Ncm, t, gr, kN, N•m, bar...
DESIG Name of the sensor e.g. sensor 1,2,3, silo, tank, mixer, balance1, motor, test1..
CALIB Selection of the sensor type (active, passive, 4-20mA, with or without calib. control..)
4.4 Operating example
- The E3907 is switched on by pressing ENTER
- Control time and date in SYSTEM menu or adjust if necessary
- Adjust language
Call menu 2 SYSTEM – 2.1 LANG. When ENTER button was pressed, the 3907 is in the selection mode. With keys
PLUS and/or MINUS the language can be selected. With ENTER the selected language will be stored. With ESC
the selected language will be discarded.
- Adjust time
Call menu 2 SYSTEM – 2.8 DATE. When ENTER button was pressed TIME will appear on the LCD. Press ENTER
again and the time can be adjusted. With
PLUS and MINUS the hours can be adjusted. After ENTER the minutes
can be adjusted with PLUS and MINUS . With ENTER the selected time will be stored. With ESC the selected time
will be discarded
- Change to the measuring mode
From menu 1 MEASUR by pressing ENTER the list of all sensors is called. With
PLUS and/or. MINUS a sensor
parameter set is being chosen. With ENTER the GM 80 is being adjusted to this sensor parameter set. With ESC it
is possible to switch back to menu 1 MEASUR from any mode.
- Change measuring rate by measuring mode
The measuring mode can be left by pressing ESC. After pressing ESC again, the GM 80 will be in menu 1
MEASUR. From there the menu 2 SYSTEM – 2.4 Rate can be called. Select RATE by key
PLUS and/or INUS . By
pressing key ENTER the set measuring rate is being displayed first. By key PLUS and/or MINUS a new measuring
rate can be adjusted. By ENTER the new measuring rate will be taken over, by ESC the new measuring rate will be
discarded..
- Switch off E3907
E3907 is switched off, when ESC button is pressed >3 seconds.
4.5 Measuring with the E3907
4.5.1 Selected sensor
Force sensor with measuring range:
200KN
Sensitivity 2mV/V
Designation e.g.: Press
Parameter set: Sensor no.: 3
Option: 100% Calibration control