TECshow HALO 7R, Руководство пользователя

Страница: 5 / 30

P. 5
| Tecshow Halo R7
English version
Encoder Pan-Tilt
NO Use encoder correct position.
OFF Do not use encoder correct position.
No DMX Signal
KEEP According to the original state continues to run.
CLEAR The return of the motor, stop running.
Display Power Save
OFF Free 30 seconds after closing backlight.
ON Backlight ever bright.
Burn on start up
OFF
Power on directly after reset, no light bulb (need to use the menu or
control table to manual light bubble).
NO
After power on automatic light bubble, must wait for the light bulb light
up success can be reset.
Load Default
Press ok key see the confirmation dialog box, again press ok key, Press
OK key into edit.
Information interface
Manual control interface
This interface use to control present light, nei-
ther belong to the from the machine state (didn’t
received DMX signal), nor belong to Host state (send
DMX signal).
Option Instruction
Total using time Cumulative using time (Accuracy to the minute).
The use of time Use of time since the boot (Accuracy to the minute).
System errors logs
If the red indicator shine ,that mean the lamps runs error. The details can be
entered sub-interface to view.
After you finish view
You can press the "OK" key to make the error log empty. Pay attention: Some-
times not the Hall or optical coupler installation problems, But the motor cable is
connected backwards.
Option Instruction
Reset Press ok key see the confirmation dialog box, again press ok key, enter the reset interface,
all motor reset.
Color Wheel 0-255
Press OK key into edit state, its selected hundred. Press up or down,change
channel value .Press again OK key, selected ten editor. Press again OK key,
select the edit. Press it again to exit the edit state.
...... 0-255
The speed of
gobo wheel
0-255
Bulb control
ON
OFF