Tecnoware UPS EVO DSP PLUS 1.0 MM, Руководство пользователя

Страница: 14 / 42

ENGLISH
User’s manual 10 UPS EVO DSP PLUS
7 First Start Up
Turning the UPS ON is very easy. Nevertheless we recommend that, on First Start Up, the following procedure is
observed for greater safety.
1. Be sure all the devices connected to the UPS outputs have the main switch in OFF position.
2. Restore the AC Input line for the UPS; be sure that the AC utility power is available, and that its voltage and
frequency are within the specifications.
3. As a consequence of point 2, the UPS turns on the led panel and goes in Stand-by mode : the UPS recharges
only the batteries and doesn’t supply Output power. Check the led panel shows the path of energy flow
during Stand-by mode.
4. Press ON/OFF button: all led will flash few second, then the UPS will turned ON and it starts to work in
Normal Mode .
5. Simulate a black-out by removing the AC Input line. The UPS starts working in Battery mode : the led panel
will show the path of energy during Battery mode. Moreover UPS emits a brief acoustic signal every 4
seconds. When Battery level is ending the acoustic signal will be emitted every 1 second.
6. Restore the AC Input line: after few seconds the UPS turns back in Normal mode .
7. The UPS has passed first start up check: now turn ON the devices (one by one) to be supplied by UPS,
checking the UPS doesn’t report
Overload information and all the devices are working regularly. By graphic
display check if the Output load percentage is less than 100%; otherwise it is necessary to remove part of the
loads at the Output lines.
Before using the UPS normally, leave it in Normal mode for in order to charge Battery completely (the UPS charges
Battery also in Bypass mode or in Stand-by Mode). The batteries reach the 90% of their capacity after about 4
hours of recharge.