Tecnoware FSTEL100KT, Руководство пользователя

Страница: 8 / 40

ENGLISH
User’s manual
4
ELECTRONIC STABILIZER
3 Receipt and site selection
Carefully remove the AVR from its packaging, and carry out a meticulous inspection. We recommend keeping the
original packaging in a secure place, in case you need to send the AVR for maintenance purposes. In case of
transport damage, notify the carrier and dealer immediately.
We recommend paying attention to the below points in order to choose a correct placement for your AVR:
•
The AVR is designed to operate in a protected environment (e.g. offices). We therefore recommend
installing it in a place with very little or no humidity, dust or smoke.
•
When the AVR is brought from a cold place to a warmer place, humidity in the air may cause condensation
in the AVR. In this case, allow AVR to stand for two hours in the warmer place before beginning with the
installation.
•
In all circumstances, see the “Technical Characteristics” chapter for environmental specifications and
check that the selected area meets these criteria.
•
During normal operation the AVR discharges a minimal amount of heat. So it is necessary to leave at least
20 cm of unobstructed space all around the AVR in order to keep it properly ventilated.
•
Do not obstruct ventilation holes.
•
Do not insert objects or pour liquids in the ventilation holes.
•
Do not rest any object on top of the AVR.
•
Do not keep liquids, flammable gases or corrosive substances near the unit.
•
Install the AVR on a properly tiled floor. Avoid the installation on a floor that is not tiled flat.
4 External Description
4.1 Front Panel
AVR informs the user about operating status, alarm conditions and measurements through a display on the front
panel (see figure 2).
Figure 2 – Front panel display