Tecnoware FSTEL100KT, Руководство пользователя

Страница: 17 / 40

ENGLISH
ELECTRONIC STABILIZER
13
User’s manual
6.2 Load Control
The AVR indicates the
Output Load
percentage by the display (#9 figure 2) on the front side.
When the Output load is higher than nominal value the AVR warns of
Overload condition
as follow explained:
•
the
Overload Protection
led (#10 figure 2) is ON.
•
a continuous acoustic alarm is ON.
The AVR has the capability to accept an Overload less than 125% for 30 seconds and then the AVR turns off.
If the Overload exceeds 125%, the AVR switches off immediately.
To turn on again the AVR after an overload shutdown, follow the steps below explained:
1.
Disconnect the output loads that cause the Overload condition.
2.
Move the
Stabilizer breaker
to the
OFF position
.
3.
Move the
Stabilizer breaker
to the
ON position
.
Make sure that the AVR never indicates Overload condition.
Do not connect a load greater than rated value to the AVR (see POWER specifications in
the chapter “Technical Characteristics”), as this may damage the unit. In this case the
warranty is void.
6.3 Manual Bypass
Manual Bypass can only be activated on the following models:
•
Single-Phase: all models except FSTEL1K2M, FSTEL2K5M, FSTEL3K5M, FSTEL6KM models.
•
Three-Phase: all models.
There is another breaker called Bypass on the left of the Stabilizer breaker.
To enable Manual Bypass, the following steps must be taken:
1.
Move the
Stabilizer breaker
to the
OFF position
.
2.
Slide the metal lock on the Bypass breaker to the Stabilizer position.
3.
Move the
Bypass breaker
to the
ON position
.
In Bypass mode, the AVR doesn’t work as a Stabilizer, but only as a Bypass between
Input and Output power lines.
To disable Manual Bypass and return to the normal operation of the AVR, follow the steps below explained:
1.
Move the
Bypass breaker
to the
OFF position
.
2.
Slide the metal lock on the Stabilizer breaker to the Bypass position.
3.
Move the
Stabilizer breaker
to the
ON position
.