TECNOVAP 4W04010, Инструкция пользователя

Страница: 22 / 36

STEAM BOX PROFESSIONAL
Pag . 22 TECNOVAP 06/15
8.1. OPERATING OF STEAM BOX PROFESSIONAL WITH KIT RADAMES
Attention!!
It is recommended to switch the steam generator off before connecting the steam hose to the
steam outlet (9).
Insert the vacuum male hose (30) into the vacuum hose female outlet (21) located on the vacuum
cleaner and the steam plug (32) into the steam outlet (9) on the machine and activate the locking lever.
Activate the general power switch (4) and the switches for the steam production and wait
approx. 3-8 minutes
(according to the machine model
) until the indicator lights up indicating
the presence of steam inside the boiler.
The switches (36 and 37) on the hose have to be turned off.
Activating the switches (36 and 37) on the handgrip the steam flow is regulated as follows: switch (36):
minimum steam, switch (37): medium steam, switches (36 and 37): maximum steam. Use the steam
command switch (34) to activate steam flow.
The switch (35A) enables you to inject detergent with the steam, it should be activated for a few seconds
at a time to avoid excess liquid with the steam; to spray hot water please refer to the below described
mode by activating the switch (35B).
Both detergent and hot water injection functions have to be activated at intermittence (for ex. 20
seconds ON - 20 seconds OFF); both functions have not to be used in continuous duty.
Attention!!
Using the switch (35B) you will get hot water under pressure which, according to the model of
the machine, can reach a temperature of 180°C; please pay attention that the switch is not
pressed accidentally and do not direct the jet against persons or animals.
To clean with steam choose the accessory best suited for the job (switch the machine off before
applying it):
The multi-purpose floor tool (51): with appropriate inserts. Inserts are locked into place by sliding the
latches (52) toward the internal side (OPEN position), pressing them upwards, then sliding the latches
toward the external side (BLOCK position).
Apply, if necessary, the extension tubes (41) and block them in BLOCK position therefore screw the
hand wheel screw (40A). It is possible to use one extension tube only.
Turbo lance steam / vac (42): to be used by itself or with the small brushes (optional), according to the
cleaning job to be executed.
Once the cleaning is finished it is recommended to vacuum approx. 3-5 litres of clean water to rinse the
inside of the hose (33) and the suction conduits. Wash and dry all accessories used. Remove the
vacuum drum and, after emptying and rinsing it, let it dry before storing it away.