GB / IE - 1
Part 1 - Installation
ELECTRIC COOK-TOPS
General Instructions
The appliance referred to in this manual has been manufactured in conformity to
the following Directives:
2006/96/CEE
“Low Voltage”;
2004/108/CEE
“Electromagnetic Compatibility.
The technical specifications of the appliance can be found on the
data plate located inside the control panel, which can be removed
by loosening the two screws under the panel.
The appliance must be installed by a qualified technician according to the
regulations and directives in force in the country where it is installed, as well as
the instructions in this manual. The appliance must only be used by trained
personnel and only for the purpose for which it has been designed. The
appliance should be checked once a year by a qualified technician.
Remove the packaging from the appliance as well as the protective plastic
sheet, and, if necessary, remove traces of glue with a suitable solvent. To
dispose of the packaging, follow local directives.
When installing the appliance, the following regulations must be observed:
Applicable national laws in force;
Regional and/or local regulations, such as building codes;
Directives and regulations of the local electricity board;
Accident prevention regulations in force;
Fire prevention regulations;
The appliance should be installed under an extractor fan for removing cooking
fumes. The appliance can be installed alone or in line. Respect a minimum
distance of 80 mm between the appliance and any walls made of flammable
material, partitions, kitchen furniture or nearby equipment. The surfaces in
contact with the appliance must be covered with non-combustible heat
insulating material. The appliance, and especially the power lead, must not be
installed anywhere near heat sources and the temperature of the place in which
the appliance is installed must not rise above 50°C.
Connection to the distribution network
The Manufacturer declines any responsibility for damage caused
by improper or incorrect installation or maintenance of the
appliance, or failure to observe safety regulations!
Before connecting the appliance note the specifications: voltage, frequency,
number of phases and power on the data plate, relevant to the power input of
the same. The installer must make the connection after having installed a main
switch, which should disconnect every pole supplying electrical power to the
appliance. The switch supplying electrical energy to the appliance must have a
minimum distance of at least 3 mm between the poles when the contacts are
open. The switch must be easy to reach. The power lead must not be installed
anywhere near heat sources and the temperature of the place in which the cable
is installed must not rise above 50°C. The cable must be protected by a rigid
metal or plastic tube. The appliance is supplied without a power cable. The
electric cable used to supply power to the appliance must at least meet H07 RN-
F standards. It must have the minimum section indicated in the table (fig.1).
To reach terminal board “
M
” (fig.2), remove the control panel by loosening the
screws on the lower part of the panel. Following the indications in the wiring
diagram, connect the wires of the power cable to the terminal board. The
appliance must be connected to a good earth. There is a screw marked with the
symbol near the terminal board where the earth conductor should be
connected. Make sure you slide the cable through the relevant hole "
P
" (fig.2)
near the terminal board, hold the cable in place until you can block it with cable
clamp (fig.1). The appliance must be connected to a good earth. The appliance
must also be connected to an equipotential earth. Connect the earth with the
screw marked on the rear panel of the appliance.
The equipotential wire must have a section of 10 mm
2
.
Содержание 716002
Страница 1: ......
