_ Electric Cookers _ rev. 1 _________________________________________________________ KCV 96 P – KCV 96_
_ CATEGORY II2H3+ _ GB __
0705
_____________________________________________________ page 9 _
Fig. a
Fig. a
Fig. a
Fig. a
Fig. b
Fig. b
Fig. b
Fig. b
Fig. c
Fig. c
Fig. c
Fig. c
Residual risks
Residual risks
Residual risks
Residual risks
-
Keep away from the appliance unskilled personel.
-
With hot oven, open the door carefully in order to avoid violent hot fumes exit, that my
cause burning.
-
The appliance contains electrical parts and must never be washed with a jet of water or
steam.
-
To avoid wrong installation, the right gas connection is showed on a label that identifies the
correct gas type to use.
-
The appliance is electrically connected: before attempting any cleaning operation, cut power
to the appliance.
-
Do not use the door handle to move the appliance (the glass panel may break).
-
The removable parts of the cooking top, after the cleaning operation, must be placed
correctly in their housing in order to avoid anomalous and dangerous functioning of the
burners.
4. Gas connection
4. Gas connection
4. Gas connection
4. Gas connection
Connect the appliance to a gas cylinder or mains gas pipe according to the prescriptions of
standards (as per current national installation norms and subsequent amendments). To connect
gas, use an approved rigid metal pipe in copper or stainless-steel (the current national
installation norms and subsequent amendments). The appliance is equipped with threaded GJ
½
” pipes for gas inflow. Check if the appliance is designed to operate on the same type of gas
as supplied and if pressure is set for that type of gas. Otherwise, carry out the operations
indicated in paragraph “ADAPTING TO DIFFERENT TYPES OF GAS”.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT -
Make sure that supply pressure matches the values indicated in the table
“Burner and nozzle characteristics” (tab.1-2).
If supply pressures do not match the values in the table, eliminate the cause of this, or inform
the gas company and do not use the appliance. Connection with rigid or flexible metal pipes
must not cause stresses to the appliance pipe (“train”).
