Tecno-gaz VITAL TEST, Руководство пользователя

Страница: 51 / 133

CAUTION:
When adjusting any menu parameters, the oximeter does not
display SpO2 or PR, but it is still recording.
1.3 Notes
NOTE:
Notes are identified by the symbol shown above. Notes contain important information that
may be overlooked or missed.
NOTE:
This device has been tested and found to comply with the requirements of IEC/EN60601-
1-2 (International standard for EMC testing of Medical Electrical Equipment, second
edition) and the Medical Device Directive 93/42/EEC. These standards are designed to
provide reasonable protection against harmful interference in a typical medical installation.
NOTE:
Sensor LED light emissions fall within Class 1 level, according to IEC/EN 60825-1:2001.
No special safety precautions are required.
NOTES:
Normal operation means:
- The oximeter is turned on;
- A sensor is connected to the oximeter;
- The sensor is applied to the patient;
- The patient’s SpO
2
, Pulse rate are being reported;
- No error conditions exist.
NOTE:
Wash the probe with clean water after disinfecting and sterilizing to remove any
remaining solution. The probe can only be reused after being dried thoroughly.
NOTE:
Do not disinfect the probe with the means of water boiled.
NOTE:
Any residue should be removed from the probe before being disinfected and sterilized,
and avoid contacting corrosive solvent. Dip the cable into alcohol or alkalescent solvent
for a long time, may reduce the flexibility of the scarfskin of the cable. Also, the connector
should not be dipped.