Tecnet TS-2116, Руководство пользователя

Страница: 11 / 16

15 16
Voice Prompts
1.Channel voice: the radio would report the channel
information when you change the channel.
2.Low Power prompt: the radio would report low
battery information when the voltage reaches the
minimum operating voltage.
3.Scan Operation Prompt: the radio would report the
information when the channel sets to the
designated scanning channel.
4.These prompts can be disabled/enabled through the
programming software.
Time Out Timer (TOT)
1. The TOT function prevents extended periods of
transmitting, which can cause possible damage to
the circuitry of the radio.
2. If transmitting occurs longer than the set time, the
radio will stop transmitting and an alarm will
sound. Cease pressing the PTT. Press PTT again to
resume transmitting.
3.Default is 180 seconds. The time duration can be
changed through the programming software.
1.VOX can be enabled to transmit without pressing
the PTT key when the voice signal is transmitted
through the microphone of the radio.
2.This function is disabled/enabled through the
programming software (default is off).
1.Through adjusting squelch level, the radio with a
lower squelch level allows weak signals to be
received.
2.Default level is 4. Levels can be changed through
the programming software, which ranges from 0-
9. When you choose 0, the squelch is open.
Higher numbers tighten the squelch reducing the
noise and interference.
Squelch Levels
VOX
Scan
1.This function is disabled/enabled through the
programming software (default is off).
2. When the scan function is enabled, channel 16
becomes the scan channel. The LED flashes green
and the radio will scan those channels assigned to
scan. If a signal is received, the radio will cease
Low Power Alert
1.When the battery power becomes low during
transmitting, receiving, or standby mode, the LED
will flash red and the radio will announce “battery
low”. You must charge the current battery or
replace with a fully charged battery.
Battery Saving
1.If there is no signal or operation after 5 seconds, the
battery saving function will occur automatically;
when signal is received or transmitted, the radio
will switch to normal power mode.
2.Multiple battery save functions can be done
through the programming software (default is on).
Advanced Operation Advanced Operation
scanning and stop on that channel for the duration
of the call.