12
The control panel of the dehumidifier you purchased may be look like one of the following:
Indicator lights (MODEL A and MODEL B)
1. Power on indicator (green)
This indicator light remains on(green) when the
unit is switched on and turns dark when the unit is
switched off.
2. Water full indicator (red)
Glows when the bucket is ready to be emptied, or
when the bucket is removed or not replaced in the
proper position.
3. Continuous operation on indicator (green)-
(
only for MODEL B)
This indicator light illuminates when the
continuous operation is on
Controls (MODEL A)
4. Power
Press to turn the unit on and off. When press this
pad, the dehumidifier will operate continuously
for maximum dehumidification until the bucket is
full
Controls (MODEL B)
5 POWER Pad
Press to turn the dehumidifier on and off. It
illuminates (green) when the unit is switched on
and turns dark when the unit is switched off.
When Humidity/Temperature sensor
malfunction occurs, it blinks at 5 times per
seconds.
6. Continuous operation
Select for the dehumidifier to operate
continuously for maximum dehumidification until the bucket is full.
The humidity set control pads cannot be used when Continuous operation is on. Press this pad
again to cancel Continuous operation
7. Humidity Set Control Pads
The humidity level can be set within a range of 35%RH(Relative Humidity) to 80%RH(Relative
Humidity) in 5% increments.
For drier air, press the “-“pad and set to a lower
percent value(%).
For damper air, press the “+”pad and set a
higher percent value(%).
8. Display
Shows the actual humidity level, at setting it shows desired level.
