background image

Derrinabrin Farm, Norwood Hill Road, Charlwood, Surrey,RH6 0EB, UK

0800 799 9082 | [email protected] | www.teckwood.co.uk

INITIAL HINTS AND TIPS FOR INSTALLING PYRODECK 

COMPOSITE DECKING

DISCLAIMER

The information given in this guide is based on guidelines for installation of domestic properties.This 
guidance does not cover any guidance for commercial decks as they require a more robust design, materials 
and construction that can deal with loads placed on them. This is just a general guide, it may not cover 
every scenario envisaged. It will be the sole responsibility of the installer for the installation methods they 
use and its performance as every installation differs and could be unique. Teckwood recommends that 
all designs should be reviewed by a licensed architect or engineer before installation, and that every plan 
or design meets that building regulations and permission before the beginning installations. Please use 
suitably qualified personnel to prevent injuries or accidents.

COLOUR EXPECTANCY

Due to sun bleach, Teckwood composite products are subject to fade, as our composite wood is manmade 
and a recycled product, thus color variations are expected. Our warranty does not cover color fade,  
water marks or discoloration or stains on our products. Our deliveries colour variations may occur in 
different batches.

STEP FINISHING SECTION

Содержание PYRODECK CLASS B

Страница 1: ... Always follow the safety precautions when operating a power washer Be sure that water effectively drains from your wood plastic composite decking For those harder to clean areas or where the castellated side of the decking may have been damaged by the dropping of charcoal etc we recommend using a 400 grit sandpaper or above Lightly sand the decking in the same direction of the grain Rinse thoroug...

Страница 2: ...uneven paving slabs or sand will cause movement Always pre drill composite wood products using a minimum of a 4 5mm drill bit If you do not you risk damaging the product over time Joists must be set to 350 mm centres If not boards may warp or move Composite boards need to be supported across their length Ends of deck boards must be supported and not have an overhang of more than 10mm If not boards...

Страница 3: ... your first board into place clipping into the Starter Clips 5 Clip Concealed Fixing Clips into the first board along each of the Joists Pre drill and screw in place See Figure C Space between boards should be 5mm 6 If joining 2 lengths of board together make sure both ends are supported by separate Joists Leave a gap calculated on the expansion rate of 0 3 0 5 of the board length to allow for exp...

Страница 4: ... installer for the installation methods they use and its performance as every installation differs and could be unique Teckwood recommends that all designs should be reviewed by a licensed architect or engineer before installation and that every plan or design meets that building regulations and permission before the beginning installations Please use suitably qualified personnel to prevent injuri...

Отзывы: