TechVision NS16P2P8, Руководство пользователя

Страница: 110 / 145

Device Management NVR User Manual
104
①
Click Start

Settings

Network

UPnP to go to the following interface.
②
Make sure the router supports UPnP function and the UPnP is enabled in the router.
③
Set the NVR’s IP address, subnet mask and gateway and so on corresponding to the router.
④
Check “Enable” in the interface as shown below and then click “Apply”.
Click the “Refresh” button to refresh the UPnP status. If the UPnP status were still “Invalid
UPnP” after refreshing it for many times, the port number would be wrong. Please change the
mapping type to “Manual” and then click to modify the port until the UPnP status turns
to “Valid UPnP”. Refer to the following picture. You can view the external IP address of the
NVR. Input the external IP address plus port in the address bar to access the NVR such as
http://183.17.254.19:81.
11.1.7 NAT Configuration
Click Start

Settings

Network

NAT to go to the interface for NAT configuration. Check
“Enable” and then select the NAT server address (
nat.autonat.com by default). Click “Apply”
to save the settings.
You can scan the QRCode through mobile client which is installed in the mobile phone or PAD
to log in the mobile client instantly.
11.1.8 FTP Configuration
Some models may not support this function.
Click Start

Settings

Network

FTP to go to the interface for FTP configuration. Check
“Enable” and enter the server name, port, username and password, max file size and remote
directory.
11.1.9
Platform Access
Some models may not support this function.
This function is mainly used for connecting ECMS/NVMS. The setting steps are as follows.
Click Start

Settings

Network

Platform Access to go to the interface.