Techroutes LLDP, Конфигурация

Страница: 7 / 25

LLDP Configuration
5
Caution: To ensure the former neighbor information is not lost owing to aging
when receiving next LLDP frame, the timeout time should be longer than the LLDP
packet transmit interval.
1.3.3 Configuring Timer
You can control the interval of the switch to transmit message by configuring the
timer of LLDP.
Run the following command in global configuration mode to configure timer of
LLDP:
Procedure Command Purpose
Step1 config Enters the global configuration mode.
Step2 lldp timer time Configures the interval of message
transmission of LLDP. The value ranges from
5 to 65534. The default time is 30 seconds.
Resumes the default interval, that is, 30 seconds.
Procedure Command Purpose
Step1 config Enters the global configuration mode.
Step2 no lldp timer
Resumes the default interval, that is, 30
seconds.
1.3.4 Configuring Reinit
LLDP information will be forwarded automatically in two conditions: first, the status
or value of one or more information elements (management objects) change; second,
the sending timer timeouts. A single information change cause the LLDP packet is
forwarded and a series of information change may cause many LLDP frames
forwarded, but a frame can only report one change. For avoiding this, the web
management defines the interval of two continuous LLDP frames. You can control the
interval of the switch to continuously transmit two messages by configuring reinit of
LLDP.
Run the following command in global configuration mode to configure reinit of
LLDP:
Procedur
e
Command Purpose
Step1 config Enters the global configuration mode.
Step2 lldp reinit time Configures the interval of LLDP to
continuously transmit message. The value
ranges from 2 to 5. The default time is 2
seconds.
Resumes the default value of reinit.
Procedur Command Purpose