Techroutes LLDP, Конфигурация

Страница: 12 / 25

LLDP Configuration
10
Step1 config Enters the global configuration mode.
Step2 interface intf-type intf-id Enters the interface configuration mode.
Step3 no lldp transmit Disables the transmit-only mode of the port.
Step4 no lldp receive Disables the receive-only mode of the port.
Run the following commands in the interface configuration mode and set lldp to
the transmit-and-receive mode.
Procedu
re
Command Purpose
Step1 config Enters the global configuration mode.
Step2 interface intf-type intf-id Enters the interface configuration mode.
Step3 lldp transmit Enables the transmit mode of the port.
Step4 lldp receive Enables the receive mode of the port.
Note: Except the above mode, the interface can also be configured to the
transmit-only mode or the receive-only mode.
1.3.8 Specifying the Management IP Address of a Port
In port configuration state, you can randomly configure the management address
of the port, from which the LLDP packets are transmitted. This management address
should be an IP address related with this port, and only in this way the normal
communication of this port can be guaranteed.
Run the following commands in port configuration mode to set the management IP
address:
Procedure Command Purpose
Step1 config Enters the global configuration mode.
Step2 interface intf-type intf-id Enters the interface configuration mode.
Step3 lldp management-ip A.B.C.D Sets the management IP address of a port.
Note: Both the no lldp command and the management-ip command can be used
to resume the default management address of the port and the default management
address is the IP address of the VLAN interface that corresponds to the PVID port.
When the corresponding VLAN interface does not exist, the management address is
0.0.0.0.
1.3.9 Sending Trap Notification to mib Database
Sending Trap Notification to lldp mib databaseor ptopomib database.
Run the following commands in the global configuration mode to sending trap notification to lldp
mib database or ptopo mib database.
Procedure Command Purpose
Step1 config Enters the global configuration mode.