Techroutes LLDP, Конфигурация

Страница: 10 / 25

LLDP Configuration
8
a) The bit rate and the communication mode
(duplex) on the physical layer;
b) Current duplex and the set bit rate;
c) Showing whether the setting is the results
of auto-negotiation in the initial connection
phase or is a compulsory manual behavior;
Step7 lldp dot3-tlv-select power (Optional) Sends the 802.3-defined TLV and
shows the interface allows the power supply
connecting to the non-power system through
the link.
Step8 lldp dot3-tlv-select link-aggregation (Optional) Sends the 802.3-defined TLV and
specifies a port to identify the aggregation if
the link can be aggregated.
Step9 lldp dot3-tlv-select max-frame-size (Optional) Sends the 802.3-defined TLV and
specifies the size of the maximum frame on a
port(byte) .
Step10 lldp med-tlv-select network-policy (Optional) Sends the MED-defined TLV and
the interface can effectively discover and
diagnose VLAN configured error-matching
flow and the attribute of layer-2 and layer-3
Step11 lldp med-tlv-select location (Optional) Sends the MED-defined TLV and
specifies the address.
a) coordinate-based LCI, which is defined in
IETF 3825[6];
b) city's address LCI, which is defined in IETF
(refer to Annex B);
c) ELIN code of the urgency call service;
Step12
lldp med-tlv-select
power-management
(Optional) Sends the MED-defined TLV and
shows the information of power supply.
Step13 lldp med-tlv-select inventory (Optional) Sends the MED-defined TLV and
shows the attribute of detailed inventory.
Run the following commands in global configuration mode to delete to-be-sent
TLV:
Procedure Command Purpose
Step1 config Enters the global configuration mode.
Step2 interface intf-type intf-id Enters the interface configuration mode.
Step3 no lldp dot1-tlv-select port-vlan-id (Optional) Sends the 802.1-defined TLV and
notifies the PVID of a port.
Step4 no lldp dot1-tlv-select protocol-vlan-id (Optional) Sends the 802.1-defined TLV and
notifies the PPVID of a port.
Step5 no lldp dot1-tlv-select vlan-name
(Optional) Sends the 802.1-defined TLV and
notifies the VLAN name of a port.