Once the transmitter is successfully recognized by the temperature station,
Channel 1 of the Temperature station will display the temperature data
measured by internal sensor and Channel 2 will display the temperature
estimated by the probe.
If the measuring probe is unplugged, the "probe channel" on Temperature
station will show "---", yet the data from the internal sensor will still be shown
on Channel 1 .
The probe can be connected to the remote temperature sensor anytime after
initial setup. There is no need to reset the units, should the probe be
unplugged or re-plugged again. The Temperature Station will automatically
detect the temperature probe data and will display the temperature data on
Channel 2 after the probe is plugged.
SETTING UP:
When one transmitter is used:
1.
First, insert the batteries into the transmitter (see “
How to install and
replace batteries in the Temperature transmitter
” below).
2.
Within 2 minutes of powering up the transmitter, insert the batteries to
the Temperature Station (see “
How to install and replace batteries in
the Temperature Station
” below). Once the batteries are in place, all
segments of the LCD will light up briefly. Then the indoor temperature
and the time as 0:00 will be displayed. If they are not shown on LCD
after 60 seconds, remove the batteries and wait for at least 60
seconds
before reinserting them. Once the indoor data is displayed, user may
proceed to the next step.
3.
After the batteries are inserted, the Temperature Station will start
receiving data signal from the transmitter.
27
