RECLINE 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 7.17
7.15. DISASSEMBLING THE PEDAL CRANK GROUP
Figure 7.15-1
Carry out the procedures described in paragraphs
7.9. “Disassembling the right and left side
casings”
1. Unscrew the right pedal
a
using a 15-mm
wrench.
2. Unscrew the 2 screws
b
fixing plate
c
with a
large Phillips screwdriver.
3. Remove the plate.
4. Open the chain or disengage it from its
sprocket.
The pulley cams can be moved to
facilitate the operation.
Figure 7.15-2
5. Using a hammer and screwdriver, open the
locking tabs to release the left-hand ring nuts
of the pedal crank group from the snap ring
clamps.
Figure 7.15-3
6. Unscrew the ring nuts as shown in the figure
at left, using 36-mm wrenches.
7. Use an extractor to remove the left-hand
bearing.
8. Remove the pedal crank from the right side.
Because the threads of the left pedal and
ring nuts are inverted, these components
must be unscrewed in a clockwise
direction.
To reassemble the PEDALS, carry out the above
steps in reverse order.
Содержание Recline 600 XTPRO
