Technogym Recline 500, Руководство по техническому обслуживанию

Страница: 129 / 182

RECLINE EXCITE: Service & Maintenance Manual - rev. 2.4
Only 700i, 700i SP and 700iE models
Figure 7.18-2
1. Move the saddle into position 8.
2. Protect the equipment frame using a cloth as
shown in the figure.
Figure 7.18-3
3. On both side, disassemble the 2 pulleys on
which the saddle moves, backing off the nut
a using a 17-mm wrench and locking down
the eccentric pin
b using a 24-mm wrench.
Figure 7.18-4
4. T
fi
5. Pay attention that the saddle stays over the
cloth and that the hand sensor interface board
cable is not t
7. Back off the two fixing screws c of the cable
holder, using a 2.5-mm Allen wrench.
urn the saddle over its back as shown in the
gure.
oo tight.
During reassembly, lock down the
screws “c” using a torque wrench set for
3 Nm.
Continued on following page
→
Page 7.35