Technogym Jog Now Excite+ 500, Руководство по техническому обслуживанию

Страница: 171 / 202

JOG NOW : Service & maintenance manual - rev. 5.1
Pagina 9.11
9.2.1.4. Table of configuration parameters (LED):
Display
parameter
Unit of
measure
Description
LED
Default
values
P01 Kmh*10 Default linear speed
8
P02 (Kmh*100)/sec Default acceleration and deceleration
100
P03 %*2 default slope set point
0
P04
Numerical
Constant
PID proportional gain
7
P05
Numerical
Constant
PID Integral gain
150
P06
Numerical
constant
S Ramp Type
0
P07 on/off Flag DC motor encoder signal alarm action
0
P08 10msec Watchdog serial communication
0
P09 1msec DC motor encoder error timeout 1 cnt = 100 msec
15
P10 on/off
Flag signal receiving Sw Emergency and not
receiving Emergency Hw
0
P11 mm roll diameter
74
P12
Numerical
constant*100 roller diameter
211
P13 on/off Flag posting warning signal AC motor encoder
0
I.e.

P01 = kmh = 8 / 10 is the 0.8kmh of start, (as if the unit was hundreds of meters times).

P02 = 100 means the acceleration expressed in kmh/sec is 100 / 100 = 1 where the 100 is the
value of the numerator and the denominator is the default 100 of formula. (cents of kmh/sec)

P03moltiplication by two is to take steps of 0.5%, this basically 2 means 1%.

Numerical Constant: P04-P05-P06 is a pure numbers, multiplicative constants used by the
firmware.

P07, P10, P13 is a Boolean flag, yes or not.

P08 is expressed in tens of msec: if P08 = 100 will be a second.

P12 = 211 means that the transmission ratios is 2.11.