Technoalarm TP4-20, Руководство пользователя, Страница: 41 / 72

TP4-20 - User Manual Programming
3-15
3.1.12.4 VIEWING OF THE FIRMWARE VERSION
On initiating the option, in the second line of the display appears the version and the
language of the firmware of the control panel.
3.1.12.5 FUNCTIONING TEST OF THE LEDS OF THE CONSOLES
On initiating the option, all the led of the consoles connected are lit.
If the led are ok, they are lit.
The led that are off, are burnt.
3.1.12.6 FUNCTIONING TEST OF THE GSM TELEPONE COMMUNICATOR
On initiating the option, in the second line of the display appear alternately the version
of the firmware of the GSM telephone communicator and the diagnostic of the
communication with the control panel.
The led of the GSM telephone communicator show signal power.
3.1.13 CONTROL PANEL OPTIONS
From the master programming menu select the submenu options.
In the option menu the following parameters can be programmed:
z
Remote access (enabling of remote programming and monitoring by the installer)
z
Protocol (enabling of the communication protocol)
Commands available
+
wy
to select the option
+
#
to confirm the selection
+
CL-EX to confirm programming and quit
3.1.13.1 ENABLING OF REMOTE ACCESS
It is possible to enable the control panel so that the installer may accede to the system
using the monitoring station in order to modify programming and monitor the system.
On the display is viewed current programming:
[ ]
Remote access disabled
[ # ] Remote access enabled
Commands available
+
#
to enable remote access
+
*
to disable remote access
+
CL-EX to confirm and quit
3.1.13.2 PROTOCOL
Permits to select one of the following communication protocols (usually software):
z
Software (standard communication with the monitoring station)
z
Ethernet (communication with the ethernet interface PROG NET)
(c) Tecnoalarm
TP420 v.0.2 ESP
Led console
Test 5
Version
Test 7
Led console
Menu 19
Options
Options
Remote acc. [ # ]
Options
Protocol
Protocol
Software
Test 8
GSM
GSM
v. 0.1
GSM
Communication ok